Concrete core cutting in Dubai and across the UAE
Concrete core cutting, also called coring or core drilling, cuts a clean round hole through a slab, wall or beam with a water-cooled diamond bit. Alpha Core Drill cuts cores from 12 mm to 600 mm, vertical or at an angle, and scans the concrete with GPR first so the core misses rebar, PT cables and live services.

12–600 mm
DIAMETERS
Any angle
DIRECTION
Water-cooled diamond bits
METHOD
GPR scan of the location
BEFORE EVERY CORE
What core cutting is used for
MOST COMMON JOB
MEP penetrations for pipes, ducts and cables
12–600mm
HVAC duct openings through slabs and walls
Drainage and plumbing routes
Cable and conduit routes between floors
Core samples for compressive strength testing
Choosing a core size
Core diameter follows the pipe or duct size plus clearance for the sleeve and fire stopping. Small cores from 12 mm suit anchors and cable routes. Large cores up to 600 mm take main drainage and ventilation ducts. Send the service sizes and we confirm the core size before drilling.
MEP sleeves
HVAC and drainage
Fit-out alterations
Cable routes
Anchor holes
Core samples
Beam and wall cores
Angled cores
How core cutting works
01
Scan
We scan each core location with GPR and mark rebar, PT cables and conduits on the surface.
02
Set up
The rig is fixed to the concrete and aligned to the marked position.
03
Cut
A water-cooled diamond bit cuts the core, which keeps dust down and the hole edges clean.
04
Clean up
The core is removed, slurry is cleared and the hole is ready for the sleeve or pipe.

Our coring equipment
We provide core cutting solutions with diameters ranging from 12 mm to 600 mm. For larger openings beyond this range, stitch coring techniques can be used to achieve the required dimensions.
Limits of core cutting
Core size and depth depend on the slab or wall thickness, access around the rig and what the scan finds. If a planned core lands on a PT cable or dense rebar, we propose a new position before cutting.
WORKS WELL
Slabs and walls
Beams and columns
Angled cores
NEEDS PLANNING
Cores through PT slabs
Very tight access
Holes over 600 mm (saw cut instead)
Core cutting cost in Dubai
A
B
Number of cores
C
Concrete thickness and steel
D
Access, height and working hours
Send the number of cores, their diameters and the concrete thickness, and we will confirm a price and a date.
Scanning, coring and cutting from one contractor
Every core starts with a scan. Our technician marks the slab and the coring crew cuts from those marks.
Concrete core cutting FAQs
What sizes of core can you cut?
From 12 mm to 600 mm in diameter. Openings larger than that are cut with wall or floor saws.
Do you scan before core cutting?
Yes. Every core location in reinforced or post-tensioned concrete is scanned with GPR first.
Can you cut cores at an angle?
Yes. Cores can be cut vertically, horizontally or at an angle.
Do you offer core cutting outside Dubai?
Yes, across Abu Dhabi, Sharjah, Ajman and Ras Al Khaimah.
Can you extract core samples for testing?
Yes. We extract cores for compressive strength testing. The lab your consultant appoints carries out the test.
Request a quote
Send the number of cores, the diameters and the concrete thickness. We will confirm a price and a date.
